Belkin NetCam HD Plus Front Casing Replacement

Written By: Destinie DiazVerdejo
  • Comments: 0
Belkin NetCam HD Plus Front Casing Replacement

Difficulty

Moderate

Steps

6

Time Required

No estimate

Introduction

This guide will walk you through how to replace the front casing on the NetCam.

  1. dINkYTvgMHGxInCZ

    • Use a wrench to loosen up the stand from the back in order to hold the NetCam more comfortably.

  2. plCkaNnbG3sgVpIY

    • Work a plastic opening tool into the seam and pry the face plate away from the back panel.

  3. 4tDMKHJx2HUaEU6t
    4tDMKHJx2HUaEU6t
    uppIOY2OIEI4SKKV

    • Use pressure to separate the covers.

    • When pulling the device apart, separate from the bottom up in order to avoid pulling the wiring at the top apart.

  4. RMPWKchKYCSq1bL1
    RMPWKchKYCSq1bL1
    SGjcGMhJUYKiHmbe

    • Use tweezers to gently pull out the white attachment from the port.

    • Use your fingers to pull out the white attachment from the tan port on the front of the board a little.

  5. 4LudN6XdrbeJbjIK
    4LudN6XdrbeJbjIK
    xjrTuWKZ1r5cQecg

    • Use a pair of tweezers to wedge between the mic and the rubber guard to remove the mic from the front cover.

    • If the rubber guard comes off with the mic just remove the guard from mic and place back on the front cover.

  6. xO52Mpaoei6XZNBQ

    • Carefully use your fingers to gently pull out the white attachment from the tan colored part.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Destinie DiazVerdejo

Member since: 04/10/16

805 Reputation

0 comments