Canon PowerShot SD1200 IS Front and Rear Covers Replacement

Written By: Jeff Casper

Comments: 1

Canon PowerShot SD1200 IS Front and Rear Covers Replacement

Difficulty

Very easy

Steps

Time Required

2 minutes

Introduction

Use this guide to replace the front and back covers of the Canon PowerShot SD1200 IS camera or to access damaged internal components.

Tools

Phillips #00 Screwdriver

Step 1

Remove the battery.

Step 2

Remove the two screws from the side of the camera casing with the strap. (4mm Phillips 00)
Remove the two screws from the bottom of the camera. (4mm Phillips 00)
Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)

Step 3

Pull off the front cover.
If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.
Remove the back cover.

It should be pointed out that the retention clips are loosened by pressing a pointed object, like a spudger point, into the tiny blind holes around the edge of the painted part of the front case.

hjd7y -