Canon PowerShot SD1200 IS LCD Replacement

Written By: Jeff Casper
  • Comments: 2
Canon PowerShot SD1200 IS LCD Replacement

Difficulty

Moderate

Steps

5

Time Required

5 minutes

Introduction

Removing the LCD screen seems intimidating, but everything comes apart rather easily. You just have to lift tabs, remove a single screw and lift out the screen.

  1. SXPIFPflM4tGJaiJ

    • Remove the battery.

  2. 4EFMgWgXLinLaGpR
    4EFMgWgXLinLaGpR
    RxTksytrIhZdwJoA
    2viHU1aN2ukmqCxR

    • Remove the two screws from the side of the camera casing with the strap. (4mm Phillips 00)

    • Remove the two screws from the bottom of the camera. (4mm Phillips 00)

    • Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)

  3. 5XO42T1yDf5YLriG
    5XO42T1yDf5YLriG
    jbrn46WlqHuqTT4o

    • Pull off the front cover.

    • If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.

    • Remove the back cover.

    It should be pointed out that the retention clips are loosened by pressing a pointed object, like a spudger point, into the tiny blind holes around the edge of the painted part of the front case.

    hjd7y -

  4. II6ILHWBfcbBQOHM
    II6ILHWBfcbBQOHM
    Qe41KgYdt2dbM5EK
    fEVpHsRZJv1iUZQA

    • Use the spudger to lift the retaining flap on the Zero Insertion Force (ZIF) tab securing the thick ribbon cable.

    • Slide out the ribbon cable using fingers or tweezers.

    • Be sure you are prying up on the hinged retaining flap, not the connector.

    • Using tweezers, disconnect the small ribbon cable below the flash assembly from the No Fuss Connector by simply pulling the ribbon cable straight out.

  5. AJvKVqVA2oEIaKOM
    AJvKVqVA2oEIaKOM
    rEOin5JoAXET2Kse
    1rDI5LZJvfNisVsH

    • Remove the L shaped brackets from the left and right side of the LCD screen with the spudger tool.

    • The Brackets have tabs that need to be pried up.

    • Remove the screw below the shutter button. (2.5mm Phillips 00)

    • Holding the sides of the LCD screen, lift the screen up and away to remove.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jeff Casper

Member since: 15/09/16

860 Reputation

One comment

Hello do you guys sello the LCD screen and do you ship to México.

Killer King -