Introduction
The lens is used for capturing specific scenes and to feed these scenes into the camera.
Tools
- 
                  
                  - 
            Position the camera so that the bottom is facing up. 
- 
            Remove the two 2.3mm screws beneath the name plate. 
- 
            Remove the two 2.8 mm screws surrounding the threaded tripod mount. 
 
- 
            
- 
                  
                  - 
            Remove the two outer 3.2mm screws from the left side of the camera 
- 
            Remove the two inner 3.7mm screws from the left side of the camera. 
 
- 
            
- 
                  
                  - 
            Pull the back face panel away from the front end of the body. This may take some wiggling and force. 
 
- 
            
- 
                  
                  - 
            After completing the removal of the motherboard, remove the tripod mounting screws (3.4mm) on the left side 
 
- 
            
- 
                  
                  - 
            Carefully pry the left side of the housing plate from the bottom of the tripod mounting plate, releasing it from the two alignment pegs next to the screws 
 
- 
            
- 
                  
                  - 
            Lift the left side of the tripod mounting plate towards you, lift free the mounting plate from the rest of the assembly 
- 
            Be careful because there are still wire connections attached to the mounting plate which you don't want to remove 
 
- 
            
- 
                  
                  - 
            Remove the 2.1mm screws from the bottom and top of the screen connecting it to the housing plate 
 
- 
            
To reassemble your device, follow these instructions in reverse order.
One comment
Camera in the pictures is not Canon Powershot S200
jkovalai -