Cirago M9030 Hard Drive Replacement

Written By: Ryan Sutardji
  • Comments: 0
Cirago M9030 Hard Drive Replacement

Difficulty

Easy

Steps

6

Time Required

10 - 15 minutes

Introduction

  1. XQJaWKtAcGEObWkZ

    • Use a Phillips #00 screwdriver to unscrew the four 1.1mm long screws on each corner located at the top of the cover.

  2. VVfcJHSIa2lEDckt

    • Similar to the last step, flip the cover over and use a Phillips #00 screwdriver to unscrew the four 1.1mm long screws on each corner located at the bottom of the cover.

    • Remove the warranty sticker across the bottom.

  3. c2J6YKqA5AyPfD2j
    c2J6YKqA5AyPfD2j
    hIpIlRajTjYxrHXq

    • Gently take the cover apart using your hands separating the top and bottom.

    • The outer shell is expected to easily come apart.

  4. iCMcNOZh6yqEerPD

    • Make sure that the screen of the device is facing down.

  5. CYoyhOlAe2IfMKHF
    CYoyhOlAe2IfMKHF
    PU4FBAPPj3DhFUtA
    mEGYnCSlTJQbg1ub

    • Using the plastic opening tool, wedge the tool underneath the bottom left edge of the hard drive.

    • Raise the bottom edge of the hard drive 15 degrees up from the device.

  6. hP5i55XQOowISIHF
    hP5i55XQOowISIHF
    UUFWrNf2HkLmS1ro
    q2GSdUcTETUUeV1o

    • Place fingers on the IDE connectors gently picking up and sliding the hard drive out from the IDE module.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ryan Sutardji

Member since: 29/06/12

171 Reputation

0 comments