Introduction
Use this guide to replace a damaged display bezel.
Tools
- 
                  
                  
- 
            
Lay the monitor screen-down so the back screws are exposed.
 - 
            
Remove the four 11.9 mm Phillips #2 screws securing the stand to the back of the monitor.
 
 - 
            
 - 
                  
                  
- 
            
Locate the two holes on the bottom of the monitor.
 - 
            
Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.
 - 
            
Continue prying along the entire edge of the monitor.
 
 - 
            
 - 
                  
                  
- 
            
When finished prying, the plastic will partially fall away from the rest of the monitor.
 - 
            
While holding the frames together, carefully flip the monitor over so it faces screen down.
 - 
            
Gently lift and remove remove the rear case from the monitor.
 
 - 
            
 - 
                  
                  
- 
            
Locate the green interface button board.
 - 
            
Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel.
 - 
            
Lift the monitor interior away from the front cover.
 
 - 
            
 
To reassemble your device, follow these instructions in reverse order.