Introduction
Tools
- 
                  
                  - 
            Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion. 
 
- 
            
- 
                  
                  - 
            Rotate the device so that it is upright again. Under the LCD Panel there is a 9.62 mm screw, unscrew using a Phillips #2 screwdriver. 
 
- 
            
- 
                  
                  - 
            Rotate the photo printer so that the bottom panel faces up once again. Now lift off the bottom panel of the case to access all internal components. 
 
- 
            
- 
                  
                  - 
            Finally remove the side panel with the ink-cartridge door by holding the right side and pulling backwards with the left side. 
 
- 
            
                            
                            Conclusion
                          
                          To reassemble your device, follow these instructions in reverse order.