Disassembling Sony Ericsson QuickShare T630 Phone Enclosure

Written By: Christine Becker
  • Comments: 4
Disassembling Sony Ericsson QuickShare T630 Phone Enclosure

Difficulty

Easy

Steps

10

Time Required

5 - 10 minutes

Introduction

This guide acts as a prerequisite for the guides following it. This will show you how to disassemble to phone enclosure in order to access the internal components of the device.

  1. HSNP4i2NU34kqdIy

    • Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

  2. LeA2P1WnA6iZ1jdq
    LeA2P1WnA6iZ1jdq
    YWLI4fJITBbV4Kan

    • Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

  3. xLDusVFEFoBRSyfG

    • Slide the battery upward to remove.

  4. cT1hfDBPRFoxJFFv
    cT1hfDBPRFoxJFFv
    XqmvPdIfnZWwRVsP

    • Remove the rubber plug located near the camera by gently prying upward with your fingers.

    • Gently lift the camera shield after removal of the rubber plug.

    The T630 phone is really old and this plug may be hard to remove as it may be decomposed like black putty. It really doesn't need to be taken off, you can get the protector for the camera off without taking out the plug when the rubber is like this.

    Lami -

  5. mKHP2FsjjQij4ifd
    mKHP2FsjjQij4ifd
    vXrrZUvPQuJPuHN2

    • Pry the remaining panel to loosen its contact to the phone using a spudger.

    • Slide the panel upward to remove it completely.

    • These steps will require a slight appliance of force.

  6. q2XO1ebbk2Bgm1TF

    • Slide the aerial upward to remove it.

  7. KsTgVwJihMHPFkm2
    KsTgVwJihMHPFkm2
    C4DgQgH5lwM6DTnn

    • Remove the four screws located at each corner of the device.

    The screws are T7 torx

    Lami -

  8. FLPFpLEhcDMC4mnV
    FLPFpLEhcDMC4mnV
    ujoh2eCa3xMhSkrv

    • Gently lift and remove the front panel of the phone after removing the screws.

  9. M32hZPp3hxAOYwor
    M32hZPp3hxAOYwor
    dQUPIH5QAmG2kbV2
    itit4nMq3tX1h6lQ

    • This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.

    • Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.

    • Gently pull the ribbon from the circuit.

    • Remove the now disconnected screen.

    there is a litttle lever on the connection on the circuit board that must be lifted up (a fingernail works fine) before pulling on the cable.

    Lami -

    you can also remove the keyboard connection (orange ribbon cable) in the same manner as for the screen cable. You can also just lift out the circuit board if you want to change the entire outer case.

    Lami -

  10. 1NXCQyteXsXnAaAL
    1NXCQyteXsXnAaAL
    uTXOcYwmitVKXItL
    lTy1Nt6CBX4HyPBX

    • Remove the keyboard by slowly pulling it away from the circuit board.

    • There are no direct connections between the keyboard and phone.

    • These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Christine Becker

Member since: 28/10/13

101 Reputation

0 comments