HP 14-an012nr RAM Replacement

Written By: Marvin lira
  • Comments: 0
HP 14-an012nr RAM Replacement

Difficulty

Moderate

Steps

3

Time Required

10 - 15 minutes

Introduction

This guide will demonstrate how to replace the RAM on an HP 14-an012nr. This guide can apply to your device if there has been a noticeable increase in load times or poor performance in executing tasks. In addition to this, an upgrade might be suitable in order to run more demanding programs.

  1. CHmytvxrBDMiVuWD
    CHmytvxrBDMiVuWD
    QkoN5hW63sHI2Ljq
    UDtcp5IKvocgFLNH

    • Remove the battery by sliding both sliders inward.

  2. sQKcfW1YUKATrFU4
    sQKcfW1YUKATrFU4
    qGCAXaufRXi2ophh
    HdBLdDmhndXQ3pU6

    • Remove the eight 6 mm screws from the back panel using a Phillips #1 screwdriver.

    • Remove the rubber pads from the upper corners of the laptop to reveal two screws on each side.

    • Remove six 4 mm screws using a Phillips #1 screwdriver.

    • Pry the back panel off using an opening tool, working your way around the edges.

  3. VBmpfdCAJlOyREoQ
    VBmpfdCAJlOyREoQ
    Pkx51PrFwuGx5LKU
    W4BRWRJ3jpOYPPLk

    • Push the two silver retaining arms apart at the same time.

    • As soon as the RAM pops out, remove it.

    • When removing or reinserting the RAM, be careful as to avoiding scratching or damaging the RAM.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Marvin lira

Member since: 07/09/23

279 Reputation

0 comments