Hamilton Beach 51101BA Rotor Replacement

Written By: Andrew Huff
  • Comments: 4
Hamilton Beach 51101BA Rotor Replacement

Difficulty

Moderate

Steps

6

Time Required

5 minutes

Introduction

After using this guide you will have learned how to replace the rotor to your blender. You will need to use basic tools to complete this guide.

  1. WODltBbsGFsX12uI
    WODltBbsGFsX12uI
    qERNsDJTV2dQJ1wx
    aINGPhAkLD43GYGk

    • Remove the container from the blender.

    • Hold the blender and the container, then twist the container in a clockwise motion.

    • Make sure to follow the lock and unlock markings on the container.

  2. ZTQ3DqfaXHJVoWu1

    • Turn the blender so the bottom is facing you.

    • Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the base.

  3. WUElt4OBIuvxObUW

    • Using a Phillips #2 screwdriver, remove the two 5 mm Phillips screws from the motor platform.

  4. 5MLD3w5dcboHuBAe

    • Unhinge the plastic motor platform from the blender.

    • You may need a plastic spudger to unhinge the motor platform from the blender.

  5. RDHNZEYLqfAyQH2i
    RDHNZEYLqfAyQH2i
    E2EmVtFIyWbbiZqN

    • Using a spudger, carefully insert the tip into the coil of wire around motor.

    • This is used to hold the rotating piece of the motor still.

    It is not clear where to put the spudder

    Quacky Ducky -

  6. CNgl1FrWcrCIBbWg

    • Remove the white rotor piece by rotating it counter-clockwise.

    • While rotating, make sure the rotating piece of the motor remains still.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Andrew Huff

Member since: 04/09/15

616 Reputation

3 comments

Hi, Any idea where to get a new rotor.

Allen Reed -

Hey! did you got the rotor?

FALGUNI SETHI -

Cómo puedo retirar la pieza blanca del rotor,si está bien socada , apretado,como detengo el rotor no de vuelta gracias

Miguel González -