How to Bind Transmitter and Reciever

Written By: Ian Glen

Comments: 2

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

Any Spektrum or DSM2/DSMX transmitter can be used with the Nano QX. If you purchased the RTF (ready to fly) model, it should come from the factory already bound to a Blade MLP4DSM transmitter.

Parts

Spektrum, DSM2/DSMX, or Blade MLP4DSM transmitter

Step 1

Disconnect the power cable and remove the battery

Step 2

If using a transmitter other than the Blade MLP4DSM, add a new model to the transmitter.
Select the appropriate model type.

Step 3

Center all trims on the transmitter.
If using the Blade MLP4DSM, press the trim buttons until you hear a long low beep (roll and pitch trim) or three short low beeps (throttle and yaw trim). This indicates that the trim is centered.

Step 4

Turn the power off on the transmitter.
Make sure the throttle is in the off position.
If using a transmitter other than the Blade MLP4DSM, make sure that all switches are in the 0 position.

Step 5

Reconnect the power cable to the battery.
Make sure not to bend the pins on the connector.
After 5 seconds, the status LED will turn blue and begin flashing rapidly, indicating that it has entered bind mode.

Step 6

Put the transmitter into bind mode while powering it on.
If using the Blade MLP4DSM, push and hold the left stick while powering on the transmitter. Release the left stick. You will hear a beep and the power LED will blink.
If using a different transmitter, consult the manual on how to enter bind mode.