Insignia NS-24ER310NA17 Disassembly

Written By: Hannah Berenjfoorosh

Comments: 0

Difficulty

Moderate

Steps

Time Required

10 minutes

Introduction

This guide will take you through the process of disassembling the housing of the Insignia NS-24ER310NA17 in order to gain access to the inner parts. This is a primary step for most replacement guides regarding this device.

Tools

Phillips #00 Screwdriver

Step 1

Rest the TV on its top edge so you have access to the base.
Use a Phillips #2 screwdriver to remove the four screws on the bottom of the base.
Remove the base from the frame.

Step 2

Lay the TV face down.
Use the Phillips #00 screwdriver to remove all of the screws from the the back of the TV.

Step 3

Stand the TV on its top edge.
Gently pry apart the front and back of the TV.
The two halves should pull apart easily since there are no longer any screws holding it together.
The two halves will still be connected by wires and cables that are taped to each side. Do not pull on these. We will remove them in the next step.

Step 4

As mentioned in the previous step, there are wires still connecting the two halves.
Remove all the pieces of tape to detach the wires from both sides.
You want to gently peel the tape off, without pulling on the wires.