Introduction
Tools
- 
                  
                  - 
            Turn the boombox around to see the back, and then flip it upside down. 
- 
            Insert a 2.5mm flathead driver into the two holes next to the battery compartment. 
- 
            Turn the driver counterclockwise several times to loosen and pull out the 17mm screw. 
 
- 
            
- 
                  
                  - 
            Peel off the two black square foams in front of the battery compartment to reveal a screw under each one. 
 
- 
            
- 
                  
                  - 
            Remove the two 8mm screws using a 2.5mm flathead driver. 
- 
            The front grey panel will loosen up once the final screw is removed. 
 
- 
            
- 
                  
                  - 
            Turn the boombox on its back. 
- 
            Release the front panel by pushing down on the latches holding the panels together. 
- 
            There are four silver latches on the top side of the panel and one on the bottom. 
 
- 
            
- 
                  
                  - 
            Turn the boombox around to view the back and lift the handle up. 
- 
            Using the same driver with 2.5mm flathead, remove the two 14mm screws under the handle. 
- 
            Gently lift the black top but do not pull completely away. 
 
- 
            
- 
                  
                  - 
            Face the bottom of the opened boombox, and detach the front panel from the back in the following order: 
 
- 
            
- 
                  
                  - 
            Unplug the 4 wires (1 red, 2 black, 1 white) from the yellow motherboard on the front panel, by pulling upwards. 
- 
            Pull the black tape attached to the white plug on the yellow motherboard by tugging upwards. 
- 
            Detach the thicker, white and pink cord on the smaller yellow plate on the front panel by pulling away. 
 
- 
            
- 
                  
                  - 
            Facing the inside of the front panel, on the corners of the grey plate, there are four screws. Unscrew these with a phillips 1. 
 
- 
            
- 
                  
                  - 
            Face the inside of the front panel. Push the buttons down gently to slide the cassette player unit out. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.