Introduction
Does your case have a crack? Want to clean out some dust or dirt trapped underneath the screen? This guide will help you take the front cover off.
-
-
Use the plastic opening tool to reach underneath the battery, opposite from the side with the red wire, and remove it from its plastic case.
-
-
-
Reach under the white plastic wire connector using the plastic opening tool and disconnect it from the socket.
-
-
-
Remove the four corner plastic covers on the back of the device using the plastic opening tool.
-
-
-
Using a Philips #00 screwdriver remove all four 4.5mm corner screws located underneath the corner pads.
-
-
-
Carefully wedge the plastic opening tool into either long side of the device.
-
Slowly move the plastic opening tool along the side of the device, separating the front and back case covers.
-
Repeat these steps on the other side of the device.
-
-
-
Once the front cover is loose, use your fingers to remove the front case cover for a new installation.
-
To reassemble your device, follow these instructions in reverse order.
