Iomega Z100S2 Case Replacement

Written By: Chris Rudolph
  • Comments: 1
Iomega Z100S2 Case Replacement

Difficulty

Easy

Steps

5

Time Required

2 - 5 minutes

Introduction

  1. XBTwtkjG1lcT1WjD
    XBTwtkjG1lcT1WjD
    iCpiKSSkSm1v5xvp

    • Push in the plastic tab that can be seen through cracks in the front left corner using a spudger.

  2. ROypR1xFGnXoSBUK

    • Move down the same side and push in the plastic tab.

  3. RTEBVUZwLOUuANWB

    • Move to the front right side and once again push in the plastic tab.

    • There is not a fourth tab to push in after this one.

  4. OKL2KDgaesLbIfn2
    OKL2KDgaesLbIfn2
    nRHTqDX4eOuQNeNR

    • Grab the cover by the front side and pull upwards.

    • You might encounter some resistance. Pull firmly, but don't yank it.

  5. MQhU1ufBL2g4VWP2
    MQhU1ufBL2g4VWP2
    Yv6UJXC5y3dhEPLJ

    • Tilt the front case down until the pegs detach from the bottom of the case.

    • Lift up and outward.

    • The motherboard will be loose at this point.

    Easy button and status light repair:

    button and plastic piece both need just 2 tiny drops of super glue.

    Donald Fournier -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Chris Rudolph

Member since: 05/10/10

82 Reputation

0 comments