Karcher Rotary Floor Cleaner 17833080 2017 Roller Brush and Suction Bar Replacement

Written By: Arthur Shi
  • Comments: 0
Karcher Rotary Floor Cleaner 17833080 2017 Roller Brush and Suction Bar Replacement

Difficulty

Moderate

Steps

9

Time Required

No estimate

Introduction

The Karcher Rotary Floor Cleaner 17833080 2017 has a pair of roller brushes and suction bars. This guide shows how to remove and replace any of the brushes and bars.

  1. cvdMERNHLdUGDK3b
    cvdMERNHLdUGDK3b
    StNjh5BI2IvnEQgF

    • Before you begin, make sure to power off and unplug the device.

    • Lift the tank by the handle and remove it from the device.

  2. jBy4DhMReckHQHZh
    jBy4DhMReckHQHZh
    Hnij1DGCDlHW4sWX
    2LQL2UnDUNjrlHnq

    • Press the yellow button near each wheel base to release the wheels.

    • Remove both wheels from their sockets.

  3. FA3CopeIFuaRydth
    FA3CopeIFuaRydth
    GxBBReuQTfSYLUCo

    • Press the yellow foot switch at the base of the device to lower the suction bars.

  4. HJFVENmeE2ED3qLd
    HJFVENmeE2ED3qLd
    uN1XHJpZGwge6N4w

    • Raise the handle to the upright position.

    • This will engage the carriage rollers and lift the device.

  5. lKv1SQdCFVICW3hv
    lKv1SQdCFVICW3hv
    ayVpTWW6bU4duAg3

    • Engage the retaining bracket to lock the handle in place.

  6. qYBSGrE6XE2GS1x6
    qYBSGrE6XE2GS1x6
    1aUG4gMlHmemSyjl
    BNqNhOyV4dSGA6Qe

    • Grasp the handle and carefully tilt the device onto its side.

  7. KQhHclU2fjTidAGI
    KQhHclU2fjTidAGI
    dtQTpIuVSk34uTwN
    jorGlN6QO5MWwQsJ

    • Tilt the top of the roller brush out of the brush well.

    • Remove both roller brushes.

  8. veGs2dJwBwa6eawq
    veGs2dJwBwa6eawq
    KjRFymTSLQbLFdtl
    TSJHEMK1FGHKtobk

    • Press the yellow button on the suction bar retaining bracket to release the suction bar.

    • If you can't see the yellow button, press the yellow foot switch at the base of the device to lower the suction bars.

  9. uLWahWmRMgEO1fMv
    uLWahWmRMgEO1fMv
    3hGreQXbreCU6Cvc

    • Remove both suction bars.

    • Reassembly tip: When you re-insert the suction bars, be sure to orient the locking tab towards the center of the device. This allows the bars to click in place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Arthur Shi

Member since: 03/01/18

272267 Reputation

0 comments