Introduction
The power cable connects the power supply to the blender.
Tools
-
-
Remove the glass container and place the blender upside down on a solid surface.
-
Remove the four rubber feet using the needle nose pliers.
-
Remove the four #7.5 Phillips 25mm screws that were located underneath the rubber feet using the Phillips #2 screwdriver.
-
-
-
Slide the knife into the metal loop holding the insulation before the white copper wire, and wiggle it back and forth until it loosens.
-
Pull the wire out from the metal loop that you loosened.
-
Repeat this process with the black copper wire.
-
-
-
Using the Phillips #2 screwdriver, remove the #8 Phillips 6mm screw to which the green wire is attached.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
