Introduction
Tools
- 
                  
                  - 
            Pull down on the button at the bottom of the phone. The battery will pop up and can then be safely removed. 
 
- 
            
- 
                  
                  - 
            To install the new battery, position the battery so that the three small metal contacts of the battery are facing the three metal contacts of the phone 
- 
            Insert the top of the battery, with the two plastic tabs, into their respective holes in the top 
- 
            Then press down on the bottom of the battery and it should snap into place 
 
- 
            
- 
                  
                  - 
            First remove the battery by pulling the tab away from the device 
- 
            Next remove the 5 rubber modules by gently prying underneath them. This will expose the screws underneath 
 
- 
            
- 
                  
                  - 
            Next remove the 6 #00 Phillips screws holding the back in place 
- 
            screws: 1.43mm head, 3.61mm length 
 
- 
            
- 
                  
                  - 
            Now, slide a plastic opening tool in between the two plastic pieces that form the outside of the back case 
- 
            Gently work the plastic opening tool around the edge of the case to separate the two pieces 
- 
            Once the case has been separated you should be able to see the circuitry inside the phone 
 
- 
            
- 
                  
                  - 
            Remove the #00 Philips screw holding the antenna in place 
- 
            Screw: 4.52mm length, 2.68mm head 
- 
            Once the screw is removed, lift the small case around the antenna off 
 
- 
            
To reassemble your device, follow these instructions in reverse order.