Logitech G Pro X Superlight Feet Replacement

Written By: Spencer Day
  • Comments: 0
Logitech G Pro X Superlight Feet Replacement

Difficulty

Moderate

Steps

6

Time Required

10 - 20 minutes

Introduction

Use this guide to replace worn-out or damaged feet (also known as skates, glides, slides, or pads) on your Logitech G Pro X Superlight wireless gaming mouse.

  1. IB1vFphPUSJDD3hf
    IB1vFphPUSJDD3hf
    cknwptAofxpmbmci
    STQygU1EY6Tymx3P

    • Slide your mouse's power switch down so it's in the OFF position.

    • A red indicator should be visible beneath the switch.

    • Unplug all cables from your mouse.

    • Flip the mouse over so the feet are facing up.

    • Throughout your repair, it may be helpful to lay your mouse on a soft cloth to stabilize it and prevent damage while you work.

  2. iSKqNoEwLkWvd1HZ

    • The feet are secured to the bottom of the mouse with strong adhesive. In order to cleanly remove them, the adhesive needs to be thoroughly heated.

    • Heat an iOpener and lay it on the mouse feet for one minute to heat the adhesive.

    • Alternatively, you can use a hair dryer on the Low heat setting to soften the adhesive.

    • If you're using a hair dryer, only heat the feet a few seconds at a time or you may warp the plastic shell.

  3. RNERSLUB1onOXCAD
    RNERSLUB1onOXCAD
    gO2CJ2jECPIIEpCJ
    uf6lE6UegGoGUhSP

    • The feet have two layers—a rubberized one and an adhesive pad underneath.

    • If you're reusing the feet, be very careful not to separate the two layers or damage the feet.

    • Carefully slide the point of a spudger under the circular foot, making sure it goes under both the foot and its adhesive pad.

    • The foot recesses have a small notch that makes it easier to slide your spudger under.

    • Gently slide the spudger farther under the foot and lift until you can grab it with your fingers.

  4. RcXKSECZFBTFEx3A
    RcXKSECZFBTFEx3A
    b5PhZr5dxrSKSJkx

    • Peel up and remove the foot.

    • If the rubber layer separates from its adhesive pad, use the same process to remove the pad.

  5. hdBc1BqmGYSknkWy

  6. 1EVHv2qPdcjfQS23
    1EVHv2qPdcjfQS23
    KSpJDAx31QasRXVb
    uYHwBT6yGIMaaSie

    • To install a new foot:

    • If any of the feet got damaged during removal or separated from their adhesive pads, replace them.

    • Use a spudger to carefully scrape up and remove any remaining adhesive bits.

    • Use isopropyl alcohol and a microfiber cloth to thoroughly clean all adhesive residue from the foot recesses. Allow the surface to completely dry.

    • Remove the feet from their backing and firmly press them into place.

Conclusion

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Author

Spencer Day

Member since: 14/09/22

88286 Reputation

0 comments