Microsoft Surface Laptop 7 (13.8-inch) Lower Case Replacement

Written By: Spencer Day
  • Comments: 0
Microsoft Surface Laptop 7 (13.8-inch) Lower Case Replacement

Difficulty

Moderate

Steps

7

Time Required

10 - 15 minutes

Introduction

Follow this guide to replace a damaged lower case (aka bottom cover) on your Microsoft Surface Laptop 7 (13.8‑inch).

  1. DgSxy3daBSoXIZNA
    DgSxy3daBSoXIZNA
    L2adWoXTRTli32DM

    • Unplug all cables and fully shut down your laptop.

  2. 1OLhjNJLTLJMcARr
    1OLhjNJLTLJMcARr
    hlS6l4Hts6TMZLW6
    jRZjDS4oJSaQwrwL

    • Close your laptop and lay it down so the rubber feet are facing up.

  3. s3FLbRNojPmjUY2b
    s3FLbRNojPmjUY2b
    NWxYixQhNN4mWDcV
    YJsxktBQKPUGk1Dt

    • Gently slide one arm of your angled tweezers into the recess near the upper right edge of one of the feet.

    • You can also use the point of a spudger. However, you're more likely to damage the foot, if you're reusing it.

    • Use your tweezers to pry up and remove the foot.

    • The feet may eject very quickly—be careful not to lose them.

    • Repeat the process to remove the remaining feet.

    • To install a foot, align the pegs on the bottom with their cutouts in the frame and press the foot into place.

  4. 4FRVeiqJuxvBwVUm
    4FRVeiqJuxvBwVUm
    KjXi2r4q3vI1hdQ5

    • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from.

    • While the Surface Laptop 7 uses Torx Plus screws, standard Torx bits work. Make sure to apply constant, downward force to prevent stripping.

    • Use a Torx Plus 5IP screwdriver to remove the four 4.5 mm‑long screws (with washers) securing the lower case.

  5. XQ4GNyTIlnlOSHPB
    XQ4GNyTIlnlOSHPB
    ExteNkfEv6lAfa2d
    AbvbbSICZkhxIc2E

    • Insert the tip of an opening pick under the top edge of the lower case, about an inch (2.5 cm) to the left or right of the Microsoft logo.

    • Don't insert the pick near the outer edges or you'll damage the antenna bar.

  6. mSPYSPoSwErGrPXn
    mSPYSPoSwErGrPXn
    WbchX4FijRPxW1WQ
    Ir1axlIHCHJR616s

    • Twist the pick to lift the lower case enough that you can grip it with your hand.

  7. KopKb1IkGwVL5JoJ
    KopKb1IkGwVL5JoJ
    Lf4lfn4HIoWSJkpR
    WLZRNwAGjgpftyVG

    • Lift the lower case and remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Author

Spencer Day

Member since: 14/09/22

88286 Reputation

0 comments