Motorola Droid Turbo Rear Case Replacement

Written By: Geoff Wacker
  • Comments: 2
Motorola Droid Turbo Rear Case Replacement

Difficulty

Moderate

Steps

2

Time Required

No estimate

Introduction

Use this guide to replace the rear case on your Motorola Droid Turbo.

  1. AXEePnT6RB6V26sV

    • Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.

    This di not work; I had to use a blow dryer.

    Caroline Downie -

  2. tCZUL1xPGuWG2N6U
    tCZUL1xPGuWG2N6U
    IjXaZOLUXmbQ2ebl

    • Use a plastic opening tool to pry the rear case off of the rest of the device.

    • Remove the rear case.

    • The wireless charging coil may try to stick to the rear case, so make sure to remove it from the case before fully separating the rear case from the rest of the device.

    I had to go around the case, starting on the non-button side, around the top and then the other side. This, unfortunately, pulled on the rear case, pressed the power button and turned the device back on. I would suggest starting on the button side and going around.

    Ryan Helinski -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Geoff Wacker

Member since: 30/09/13

90840 Reputation

0 comments