Ninja Mega Kitchen System BL770 Circuit Base Replacement

Written By: Tommee Walker
  • Comments: 4
Ninja Mega Kitchen System BL770 Circuit Base Replacement

Difficulty

Moderate

Steps

4

Time Required

No estimate

Introduction

This will work as a prerequisite guide for all other guides. This helps us break down the device into the main base layer.

  1. JLqY1bSiWEmExw46
    JLqY1bSiWEmExw46
    OYEJIVAamIPcRN1S

    • Remove the five screws (13mm long, 6mm head) attaching the Base Cover using a Phillips screwdriver (Ph2).

    • Remove the two screws (13 mm long, 6mm head) attaching the Base Cover using a T10 screwdriver.

  2. SJWePFDgCtIKYmQB

    • Carefully remove the second layer from the base. You will not need a screwdriver for this step.

  3. WRAwfOqGoxRXUEEj
    WRAwfOqGoxRXUEEj
    ed1WJUCCSKCPdjmZ
    Whu1UiPQPE3svTXH

    • Remove the 2 screws (13mm, 6mm head) connected to the plastic piece holding down the power cord.

    • Then remove the additional 4 screws (13mm, 6mm head) and 2 screws (11mm, 5mm head) securing the base.

    • Carefully lift the base up from the rest of the blender.

  4. y2TUD22VPjCxOesu

    • Remove 4 screws (11mm, 4mm head) connecting the circuit board to the base.

    Where can I buy a new board?

    Forrest Lowe -

    Mein yeh circuit board kharidna chahta hoon kha se milega

    Pravjot Singh -

    Same question here

    Diego -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tommee Walker

Member since: 23/08/17

823 Reputation

One comment

Hey Tommee where can I get a circuit board for the ninja bl 773.

Bhesham Sochan -