Introduction
Tools
- 
                  
                  - 
            Remove the back cover of your cell phone by applying slight pressure with your thumb and pushing up towards the top of the phone. 
- 
            Lift off back cover. 
 
- 
            
- 
                  
                  - 
            Use your index finger to first push down and then lift up the battery as shown. 
- 
            Remove battery from cell phone. 
 
- 
            
- 
                  
                  - 
            Unscrew two T5 torx screws easily visible on the back side of the cell phone 
- 
            Screws: 7.8mm 
- 
            Once screw are removed, the phone will separate easily into two pieces connected by a flexible wire strip. 
 
- 
            
- 
                  
                  - 
            Use an iPod opening tool to gently pry open the back case as indicated in the picture. 
- 
            Work your way down the side of the phone starting from the top down to the bottom. (Use multiple prying tools if necessary) 
- 
            REPEAT on both sides, and be careful not to stab the circuitry with the tools. 
 
- 
            
- 
                  
                  - 
            Gently pull the phone apart and the flexible wire should detach from its connection as shown. 
- 
            If not, lift up on the black tab within the left box in the picture. 
- 
            With the front half of the phone, push the keypad towards the removed portion of the phone. 
- 
            To clean, use a damp cloth with water. 
 
- 
            
- 
                  
                  - 
            Use a T6 Torx Screwdriver to remove the screw located in the bottom right corner of the back panel. 
- 
            Screw: 6.4 mm 
 
- 
            
- 
                  
                  - 
            After removing the logic board from the back of the phone, pry the speaker out from the bottom with an iPod opening tool. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.