Nokia Lumia 925 Display Replacement

Written By: Guillermo Lara
  • Comments: 0
Nokia Lumia 925 Display Replacement

Difficulty

Moderate

Steps

7

Time Required

2 minutes

Introduction

  1. D2K1cjSxhWotJkQA
    D2K1cjSxhWotJkQA
    UHQytq1YNk6WlXPT

    • Remove the sim card holder by inserting tweezers into the hole. Push down and the holder will spring back up.

    • Pull out the holder until it is completely separate.

    • Something like a paperclip will work if there are no tweezers available.

  2. P4BchHIZe13JHBO5
    P4BchHIZe13JHBO5
    hZnMDGlVYYclFfyO
    FwTZNAFDBPmQSnbR

    • Slide a plastic opening tool under the back cover.

    • Slide the tool around the outsides of the cover to fully dislodge the pins holding the cover to the phone.

    • Some pins are facing the opposite way from the others.

  3. M1EEZw6dMPQLiux1
    M1EEZw6dMPQLiux1
    Km1nFSwCWbW5TBAn
    ZMWk2RGfhrOlogaw

    • Remove the 3 screws using the T7 Torx screwdriver.

    • Unclip the black tab connector.

  4. Egu3jH5lGZRSJmGf
    Egu3jH5lGZRSJmGf
    nEJigTa64fctlWvd

    • Remove the silver metal cover.

    • Be careful of the tape under the right square side of the panel. Using a spudger helps.

  5. qnfdrSiUgD6DLbEj
    qnfdrSiUgD6DLbEj
    XaXpTk5NYVURahQY
    HxHpgmgwhYiiUgVn

    • Unclip the two orange tabs.

    • Remove the four silver screws using the T5 Torx screwdriver.

  6. TnOJkkotCZNGsR6a
    TnOJkkotCZNGsR6a
    5VmyrsGQ1tUvdwek

    • Remove the motherboard by sliding tweezers between it and the back of the screen. Lift up.

  7. fGDMRZFeXC5gDdtE
    fGDMRZFeXC5gDdtE
    IgpXaCHtZhpnAUd3

    • Push the screen from the inside of the phone.

    • Pull the screen off.

    • Slide the electronic strip through the small opening.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Guillermo Lara

Member since: 18/09/18

409 Reputation

0 comments