Nostalgia Electrics RHP-310 Housing Replacement

Written By: Dana Clarke
  • Comments: 1
Nostalgia Electrics RHP-310 Housing Replacement

Difficulty

Moderate

Steps

8

Time Required

10 minutes

Introduction

Follow the steps for replacing the power switch. This guide will start right after replacing power switch ends.

  1. EXxHyigiNay1KbNI

    • Unplug the popper.

    • Lift the lid up to remove it.

  2. Sk2mLMGtX3BFyIag

    • Lay the popper on its side.

    • Remove the five 12mm Philips #2 screws around the perimeter of the base with the Phillips #2 screwdriver.

    • Remove the two 15mm Philips #2 screws in the center of the base with the Phillips #2 screwdriver.

    • Put the removed screws in a safe place, they will be needed later to reattach the housing to the base.

  3. OOr3nmxYUA6ILjRV

    • Flip the base over to view the interior of the base panel.

    • Unscrew the two 10 mm Philips #2 screws from the base panel.

    • Remove the base and set it aside.

  4. XwiQIcGVxEOQcewd
    XwiQIcGVxEOQcewd
    nCZSOIRQBoRLfVBT

    • Locate the power switch connected to the side of the housing.

    • Pinch the sides of the power switch.

    • Push the power button up and out of the housing.

  5. wIdmPPc26XSJBNpi

    • Remove the wires connected to the power switch that should be detached from the housing.

    • Gently pry the wires loose from the power switch with the plastic opening tool.

    • The wires should easily pop out from the power switch.

  6. AsNWdq21gBqTFJOU

    • Remove the power switch from the housing unit.

    • You can now replace the power switch, if necessary.

  7. dekQ21STvvDStVSo
    dekQ21STvvDStVSo
    EoauvG4UqK6woNj3

    • Gently remove the heating component from the popper.

    • Unscrew the four screws (11mm Philips #2 screws) that connect the white top to the housing.

    • Save the screws from this step. You will need them to connect the new housing to the white top.

  8. PV1Kn1gIVoOLEJV4

    • Remove the white top from the housing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Dana Clarke

Member since: 26/09/12

50 Reputation

One comment

Hello thank you very much. I need the electrinonic circuit because one component it's broken . Hoy can i get it. Thank you very Much!

cris nav -