Oster BLSTSS-PZO Circuitboard Replacement

Written By: Tristian Cruz
  • Comments: 2
Oster BLSTSS-PZO Circuitboard Replacement

Difficulty

Difficult

Steps

5

Time Required

30 minutes

Introduction

The circuit board is the main control center of the blender.

  1. ZE1xoaP6vccOfjOT

    • Use the prying tools to open the four plastic screw holes on the bottom of the blender.

  2. eJkjXYteu3S2tHkN

    • Use the Phillips #1 Screwdriver to unscrew the four 16 mm screws and remove the plastic bottom.

  3. OnYKUHU1TpLFTkcr

    • Gently remove the circuit board.

  4. RBYBkGuNb1BXVi2H
    RBYBkGuNb1BXVi2H
    u4m3GXNZ4gQOZn4h

    • Use the spudger to detach the black wire from the circuit board.

    • Repeat for yellow wire.

  5. V1l4wRiVu2mnFqAY
    V1l4wRiVu2mnFqAY
    nUfyk1OWlXEgYyt3
    sVSCadm2upJGTkhF

    • Use the Phillips #1 to remove the four 8mm screws.

    • Use the medal spudger to detach the circuit board from the buttons.

    • Gently pull and release circuit board from buttons.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tristian Cruz

Member since: 20/09/17

263 Reputation

2 comments

Where can I get a replacement part for this PCB assembly? My buttons stick and don’t work properly.

It’s the button pushing assembly that’s defective.

Jeff -

Where can I get a replacement part for this PCB assembly? My buttons stick and don’t work properly.

It’s the button pushing assembly that’s defective.

Jeff -