RCA 8 Apollo Back Panel Replacement

Written By: Chantel Pfiefer
  • Comments: 0
RCA 8 Apollo Back Panel Replacement

Difficulty

Moderate

Steps

3

Time Required

No estimate

Introduction

Use this guide to replace the back panel on your RCA Apollo 8 tablet (identified with model number RCT6573W23).

  1. GUBQMbeSBUZN4U2A

    • Before you begin, discharge your tablet battery below 25%. A charged lithium-ion battery can catch fire and/or explode if accidentally punctured.

    • Power off your tablet before beginning to disassemble.

  2. pPxyYSIdrRqYsxYy
    pPxyYSIdrRqYsxYy
    sByWnyxSEAdsctNl

    • Insert an iFixit opening tool into the gap between the tablet and back panel.

    • Using a combination of iFixit opening tools and iFixit opening picks, pry the tablet upward around its perimeter to release it from the plastic rear case.

    • If inserted too far, an opening pick can damage your device. It is helpful to mark the edge with an opening pick, or opening tool at a depth that will not damage the inner contents of the tablet.

  3. rPVOxBZl6WPjPgBJ
    rPVOxBZl6WPjPgBJ
    PYQUHGrZmVR1UlKI

    • Disconnect the red and black speaker wires from the tablet.

    • The front and back of the tablet will be disconnected.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Chantel Pfiefer

Member since: 15/04/24

219 Reputation

0 comments