Razer Basilisk V3 Motherboard Replacement

Locate each of the skates.

Heat the skate using a heat gun or hair dryer.

Using the pointy end of the spudger pry away a corner of the skate.

Once the corner of the skate comes free use the flat end of the spudger to peel off the rest of the skate.

Repeat these steps for each of the skates.

Remove two 4.8 mm screws that were hidden under the skates using a JIS #1 screwdriver.

Remove the single 4 mm screw beneath the thumb grip using a JIS #1 screwdriver.

Heat the label gently with a heat gun or hair dryer.

Once the adhesive is loosened, use a spudger to peel off the label carefully, revealing two additional screws.

Remove the two 4.8 mm screws using a JIS #1 screwdriver.

Carefully pry apart the mouse's top and bottom halves. Using the iFixit opening tool, start at one corner and work around the edge.

Using a plastic opening tool, gently pry the connector apart by moving side to side to avoid bending the pins.

Use the flat end of the spudger to pop-out the scroll wheel assembly.

Pull up on the top half of the cable connector and pull the cable from the connector.

Remove six 4 mm screws using a JIS #0 screwdriver.

Insert the flat end of a spudger in the gap between the motherboard and the rest of the mouse.

Slowly pry up the edge of the board, moving around the mouse slowly in a counterclockwise direction.

Unplug the cable connection.

Feed the cable through the hole in the motherboard.