RedOctane X-Plorer Keys Replacement

Written By: Ashley Slocum
  • Comments: 0
RedOctane X-Plorer Keys Replacement

Difficulty

Easy

Steps

6

Time Required

15 minutes

Introduction

The guitar keys can wear out over time or stop working completely. This guide demonstrates how to successfully remove the keys to diagnose internal problems.

  1. JIBJhRBCTFMaGZEb
    JIBJhRBCTFMaGZEb
    KDaZAT2OdqXMIOpw

    • Remove the strap by pulling it off of the mounts located on the body and neck.

  2. Z6NeWqWKCmvMvv4Z
    Z6NeWqWKCmvMvv4Z
    YaZR1dPqeZSqYA1a
    kNF5WcAqZvumRW6W

    • Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.

    • Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.

    • These screws can also be Torx on some models.

    • Pull off the rear case.

  3. DdfDy1Jb3mwwArHN
    DdfDy1Jb3mwwArHN
    WOOF5VYDnjE6MRiE
    LVKGSYRTgqcnpDIB

    • Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.

    • Pull off the top shell of the neck to expose the internal features.

  4. IASDH1UFMOjVnmjw
    IASDH1UFMOjVnmjw
    eZJOVx6IHXmojiVU
    fkFIJeUIvRDFsGPV

    • Use a screwdriver to remove the 10 mm Phillips #1 screws from the key sensor board.

    • Lift up on the key sensor board to remove it from the guitar neck.

    • When using the screwdriver, make sure to avoid puncturing the wires.

  5. FObiPiL1UCaSTxD1

    • Using your fingers, remove the rubber pad to expose the colored keys.

  6. HpfPXRbPeO1H1qmY
    HpfPXRbPeO1H1qmY
    YYfYpnLCV61nqZgo

    • Reach one finger under the guitar to push the key out of the casing.

    • Repeat this step for the four remaining keys.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ashley Slocum

Member since: 18/04/18

189 Reputation

0 comments