Introduction
The RJ-14 connector is designed to connect to pedals that do not come with the device. This guide will show you how to replace the RJ-14 connector located at the bottom of the guitar.
Tools
-
-
Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.
-
Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.
-
Pull off the rear case.
-
-
-
Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.
-
Pull off the top shell of the neck to expose the internal features.
-
-
-
Remove the two 10mm Phillips #1 screws from the RJ-14 connector board.
-
Lift the RJ-14 connector to remove it from the case.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
