RedOctane X-Plorer Strum Bar Sensor Board Replacement

Written By: Riley
  • Comments: 0
RedOctane X-Plorer Strum Bar Sensor Board Replacement

Difficulty

Easy

Steps

4

Time Required

20 minutes

Introduction

The strum bar sensor board will often wear and stop working over time due to overuse. This guide demonstrates how to replace the strum bar sensor board.

  1. JIBJhRBCTFMaGZEb
    JIBJhRBCTFMaGZEb
    KDaZAT2OdqXMIOpw

    • Remove the strap by pulling it off of the mounts located on the body and neck.

  2. Z6NeWqWKCmvMvv4Z
    Z6NeWqWKCmvMvv4Z
    YaZR1dPqeZSqYA1a
    kNF5WcAqZvumRW6W

    • Remove the nine 12mm Phillips #1 screws around the perimeter of the case with a screwdriver.

    • Remove the two 15mm Phillips #1 screws connecting the body panel to the neck panel with a screwdriver.

    • These screws can also be Torx on some models.

    • Pull off the rear case.

  3. DdfDy1Jb3mwwArHN
    DdfDy1Jb3mwwArHN
    WOOF5VYDnjE6MRiE
    LVKGSYRTgqcnpDIB

    • Remove the five 12mm Phillips #1 screws along the neck with a screwdriver.

    • Pull off the top shell of the neck to expose the internal features.

  4. xrhQdnyeKGXlMtwZ
    xrhQdnyeKGXlMtwZ
    1J2P1nZBYCHbXs4V
    STYQSZKQNI4qDRGL

    • Use a screwdriver to remove the four 14mm Phillips #1 screws around the perimeter of the strum bar sensor board.

    • Lift up on the strum bar sensor board to remove it from the case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Riley

Member since: 18/04/18

649 Reputation

0 comments