Introduction
Tools
- 
                  
                  - 
            To repair a short in the wires, the head band has two screws, just above the headphones cups. 
 
- 
            
- 
                  
                  - 
            After removing the two small screws, try closing the headband to it's shortest position. The outer panel will pop out toward the bottom edge. 
- 
            You can then slide the panel out from under the collar. The collar may slide out of place while working, but can easily be slid back during re-assembly. 
 
- 
            
- 
                  
                  - 
            After inspecting the wire inside, you may notice cracks in the corners were the wires bend when the headphones are folded. I cut a thin strip of electrical tape to use as reinforcement. 
- 
            After sliding the collar up, you can extend the wire, giving you better access for wrapping or replacing. 
 
- 
            
                            
                            Conclusion
                          
                          To reassemble your device, follow these instructions in reverse order.