Introduction
If the motherboard needs to be replaced, this guide will demonstrate how to do so.
Tools
Parts
- 
                  
                  - 
            Gently pry back the metal flap on top of the connector. 
- 
            Locate the two 2.0 mm black screws and unscrew using a Phillips PH00 bit. The connector will detach from the device. 
 
- 
            
- 
                  
                  - 
            The motherboard is attached to the display using an adhesive 
- 
            Using a heat gun, heat up the display for 4 to 5 minutes, making sure the move the heat gun around to distribute the heat around the display. This heats up the adhesive making the motherboard easier to remove 
 
- 
            
- 
                  
                  - 
            Using a plastic opening tool, carefully insert the opening tool in between the bezel and the motherboard and slide it the entire length of the logic board. 
- 
            Slowly pry up the motherboard from the display. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.
One comment
Had to build a cradle, keep breaking, do not know out the 5 brass pronges which is pisitive and negative, how is there no schematic of the gear watch??