Introduction
This guide is used only as a precursor to the battery, vibrator motor, and heart rate monitor removal and replacement.
Tools
- 
                  
                  - 
            Press the watchband down against the work surface. 
- 
            Press the tip of a flathead screwdriver against the edge of the spring-loaded holding pin. 
 
- 
            
- 
                  
                  - 
            With the spring-loaded pin pressed in, the watch band should release easily. 
- 
            Gently pull the band away from the body of the watch. 
- 
            Repeat steps 2 and 3 for the opposite side. 
 
- 
            
- 
                  
                  - 
            With the watch laying face-down, locate the four screws. They are located on the back of the watch, at the four corners. 
 
- 
            
- 
                  
                  - 
            With the watch’s back cover pried loose, gently lift it away from the front half of the watch. 
 
- 
            
To reassemble your device, follow these instructions in reverse order.
One comment
Mention the screwdriver in the tools needed section.
Be sure to proofread carefully.
Dan Brown -