Samsung RF28R7201SG Refrigerator Evaporator Cover (Freezer Compartment) Replacement

Unplug your refrigerator before you begin your repair.

Slide the freezer drawer fully open.

Lift and remove all the freezer bins from the drawer.

Use a flathead screwdriver to press in the plastic tab near the inner end of the drawer rail.

As you press the plastic tab, grasp the rail with your free hand and slide it towards you slightly to unlock the rail.

Repeat the rail unlock procedure on the other drawer rail.

Once both rails are unlocked, firmly pull both rails to slide them out of the refrigerator wall guides.

Remove the freezer drawer.

Push the geared torsion bar until it rests at the very end of the rails.

Align the drawer rails to the refrigerator wall guides.

Close the freezer drawer until the rails lock back in place.

Use a Phillips screwdriver to remove the two 16.2 mm-long screws securing the freezer evaporator cover.

Use your hands to lift the bottom edge of the evaporator cover up to release the lower plastic tabs.

Swing the evaporator cover upwards to access the connected wires behind it.

Use your fingers to squeeze and disconnect the fan cable connector from the back wall of the freezer.

Remove the evaporator cover.