Sceptre X9 Komodo VII Board Cover Replacement

Written By: Ted Hsueh
  • Comments: 0
Sceptre X9 Komodo VII Board Cover Replacement

Difficulty

Moderate

Steps

5

Time Required

10 minutes

Introduction

  1. 3sPuGEhNBVpLArdB

    • Place the monitor face down.

    • Remove the four 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the stand by pulling it out.

  2. mSwIVPnA2JCXfvZC

    • Remove two 11.5mm screws with a #2 Phillips screwdriver.

    • Remove the plastic bar.

  3. QApVk5V3iLBajqsT

    • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

  4. NuEXVFr5hSwrHx3N
    NuEXVFr5hSwrHx3N
    Pb6ZKs3L1kP5fvEZ
    aaTX1YjIrYvKBDWV

    • Pry the monitor using the plastic opening tool to release the clips holding the cover on.

    • There are four clips on each side, four on the top, and one on the bottom.

    • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

    • Once all the clips have been released, remove the cover by pulling it up.

  5. ERlC4wPeEIZHpWvE
    ERlC4wPeEIZHpWvE
    wZtE2IyGcYFYaMNp

    • Using the #2 Phillips screwdriver, remove the one 6mm screw.

    • Unplug the indicated cable by pulling on the base.

    • Slide the cover toward the top of the monitor.

    • Remove the cover.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Ted Hsueh

Member since: 20/09/12

170 Reputation

0 comments