Sony DVP-FX730 Monitor Replacement

Written By: Andrew Ward
  • Comments: 0
Sony DVP-FX730 Monitor Replacement

Difficulty

Moderate

Steps

10

Time Required

10 minutes

Introduction

If the monitor or screen is broken, the monitor needs to be detached from the Sony DVP-FX730. To detach the monitor successfully, a screwdriver should be used to remove screws, use your hands to pull remove a small back cover, and use tweezers to remove wires attached to bases.

  1. MxZBHasVeyxTJBYL

    • Remove the five exposed 7.9 mm screws using a Phillips screwdriver.

    • Punch through the warranty sticker with the spudger.

    • Remove the screw underneath with the Phillips screwdriver.

  2. lZxjSvCoWm2XFKOm

    • Remove the rubber feet using the spudger.

    • Remove the screws that were covered by the rubber feet.

  3. AVWgyiIjyeEQDVBr

    • Hold on to the corners of the cover and gently lift the cover.

    • The tray is still connected to the base with wires.

  4. 2xUjXfWDYcJUr3UG

    • Gently remove the wires with tweezers by pulling up on the base they are attached to.

  5. dyRreMXWwPrhg5m6
    dyRreMXWwPrhg5m6
    Ppnf23LoTb1CRRiZ

    • Use your hand to remove the small back cover by gently pulling upward.

  6. QbQ5UVtfVqPHXrAe

    • Using a screwdriver, remove the two 12 mm pan head screws.

  7. OYNXlQLECAmgMCfl

    • The screen should now detach from the primary device.

    • The wires, indicated with a blue box, will still connect the screen.

  8. Q2jICIvnbrvSodjQ
    Q2jICIvnbrvSodjQ
    12OQosrTsiIPEWch

    • Remove the wires attached to the white base using tweezers to pull them up.

  9. jyAfqYOWvitDPKCY
    jyAfqYOWvitDPKCY
    NGPsRQmImmSGWxOH

    • Referring back to Step 8, do the same with the wires attached to the black base.

  10. 5XMImW4U2S6YSZE3

    • The screen should now be completely separated from the main device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Andrew Ward

Member since: 20/01/12

111 Reputation

0 comments