Introduction
The only hard thing about the guide is making sure the wire does not get in the way!
Tools
- 
                  
                  
- 
            
Remove the 2 rubber foot pads from the bottom (opposite the hinge) with the small Plastic Opening tool.
 
 - 
            
 - 
                  
                  
- 
            
Remove the tape holding the speaker wire to the battery on both sides using a small opening tool.
 
 - 
            
 - 
                  
                  
- 
            
Remove the 4 Phillips 3.2 mm screws holding the battery in place, with the Phillips #1 screwdriver.
 
 - 
            
 - 
                  
                  
- 
            
To disconnect the wire from the mother board, gently press down with the flat end of Spudger and pull on the wire.
 
 - 
            
 - 
                  
                  
- 
            
Remove the 4 Phillip 6.3 mm screws from both the right and left speakers using Phllips 1 screwdriver.
 
 - 
            
 
                            
                            Conclusion
                          
                          To reassemble your device, follow these instructions in reverse order.