Toshiba Satellite L55-A Back Cover Replacement

Written By: Arthur Shi
  • Comments: 0
Toshiba Satellite L55-A Back Cover Replacement

Difficulty

Easy

Steps

7

Time Required

10 - 20 minutes

Introduction

Follow this guide to remove the back cover of the Toshiba L55 laptop. This requires partially removing the DVD SuperMultiDrive, as a metal tab is trapped underneath it.

  1. GkHsHhZuhlLvuoiF

    • Before you begin, be sure to power down your laptop.

    • Flip the laptop over so that the back cover is facing up.

    • Unscrew the captive Phillips screw securing the RAM cover.

  2. NZIjXWNgUBOyS653
    NZIjXWNgUBOyS653
    aIharJKMZFAQNUEA

    • Lift up the edge of the RAM cover and remove it.

  3. cmc3jyqAxqpm3McF
    cmc3jyqAxqpm3McF
    jr3GN1dhUOJALPIg
    FVGPWqUB25XDEFuU

    • Use an opening tool to pry up the ethernet connector cable from its socket near the RAM module.

    • Disconnect the cable.

    • During reassembly, make sure you re-insert this connector right-side-up. The connector is keyed to plug in only one orientation, so if it doesn't slide into place easily, turn it around and try the other way.

  4. jTa4SbGremKkSaeu

    • Remove the thirteen 6.8 mm long Phillips screws securing the back cover.

  5. TtSNaVlQgkBRRZEV
    TtSNaVlQgkBRRZEV
    fB2JoGFGkPdTLtZj
    LpsJYlEINGvcNYa2

    • Insert the point of an opening pick in the seam between the SuperMultiDrive and the rest of the back cover.

    • Push the SuperMultiDrive's lip away from the back cover to disconnect the drive.

    • Slide the drive out of the bay and remove it from the laptop.

  6. DX5CQGXCgEgTGPhA
    DX5CQGXCgEgTGPhA
    3lAEMqYBbfWEQaMR

    • The back cover is still held in place by plastic clips.

    • Insert the point of an opening pick into the back cover seam near the ethernet port.

    • Twist the pick to release the plastic clips along the edge.

  7. 3yaXgCRCOxKKVRGl
    3yaXgCRCOxKKVRGl
    YaUDIUWksbjXD2fy
    cVodCvhUCcGNa6yD

    • Grasp the loosened back case edge with your hand and lift it slowly away from the laptop. The remaining clips should release with ease.

    • If you meet significant resistance, stop and check for forgotten screws.

    • Remove the back cover.

    • To reinstall the back cover, align the cover and press along the edges to snap the clips back in place.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Arthur Shi

Member since: 03/01/18

272264 Reputation

0 comments