Introduction
If the front-facing or rear-facing camera on your Trio Stealth-10 is no longer functioning, replacement isn't difficult and this guide will give you the step by step procedure to do so.
Tools
-
-
To remove the back panel, you will need to use a plastic opening tool and slowly separate the back panel from the device.
-
-
-
Disconnect the camera from the mother board. Use a spudger and lift the grey latch until it is facing up then pull out the connection for the cameras.
-
-
-
Remove the second layer of tape above camera cable connection gently and remove the cameras from the device.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
