Why! WDi7SSD SSD Hard Drive Replacement

Written By: Felice Suglia
  • Comments: 0
Why! WDi7SSD SSD Hard Drive Replacement

Difficulty

Easy

Steps

6

Time Required

10 - 15 minutes

Introduction

Replace the 120GB SSD hard drive with an equal or larger hard drive.

  1. siOpmGjiGNXFiThs
    siOpmGjiGNXFiThs
    3XUXlcpWsBgywMTH
    1so5casIitQ6nMQ2

    • Make sure the computer is disconnected from the power source.

    • Flip the computer over.

    • Remove the six screws with a 2 mm Allen key.

    • Carefully remove the back panel, as well the left and right panel.

  2. OmEmrO3XIO4weBLF

    • Now flip up the base panel to which all components are attached.

  3. FMKXWgCTMAayOktn
    FMKXWgCTMAayOktn
    DwKZO4FHBYFcONIe
    3KTGiJqB2pN3bnJP

    • Using a Phillips #2 screwdriver, remove the four screws on the heatsink that cools the processor unit.

    • Remove the heatsink.

  4. Ld2JQduBFU1rfTo2
    Ld2JQduBFU1rfTo2
    EAqUewfIM1ENHFG2
    6TTVmDc3MAHllwLs

    • The SSD is now visible.

    • Now flip the computer over and use the Allen wrench to loosen the 1.5 mm screws fixing the SSD.

  5. T3peEw3K6RkRcXNM
    T3peEw3K6RkRcXNM
    DFIt2JHimVKDcubg

    • Disconnect the first cable from the SSD. You must press the lever down to do this.

    • The cable may not loosen easily. In this case, carefully use a little force, but not too much.

    • Pay attention do the orientation when assembling. Otherwise, the SSD and cable can be damaged.

  6. WmB5R53KxZjeeBUO
    WmB5R53KxZjeeBUO
    JZj1M2vNBFIEIHNH

    • Disconnect the second cable from the SSD. You must press the lever down to do this.

    • The cable may not loosen easily. In this case, carefully use a little force, but not too much.

    • Pay attention do the orientation when assembling. Otherwise, the SSD and cable can be damaged.

Conclusion

To reassemble the device, follow the instructions in reverse order.

Author

Felice Suglia

Member since: 15/06/13

31549 Reputation

0 comments