ZTE Quest n817 Camera Replacement

Written By: Eric Loureiro
  • Comments: 0
ZTE Quest n817 Camera Replacement

Difficulty

Moderate

Steps

9

Time Required

1 minute

Introduction

Has your ZTE Quest’s rear-facing camera been badly scratched or damaged? This guide will provide instructions on how to replace your camera. All you need is a plastic opening tool, some tweezers, and a JIS #000 screwdriver.

  1. KMxZYAPOXcjxiC1n
    KMxZYAPOXcjxiC1n
    ZG4EZO2IiwvOJqgw
    JIC3n2c4OtZ1NUOL

    • Ensure that the phone is turned off before starting.

    • Orient the device so that the inset on the right side of the device is facing you.

    • Insert the spudger into the inset and carefully remove the back panel.

  2. JiYp4OVJ6rCXP3tY
    JiYp4OVJ6rCXP3tY
    jXX6k6jxNaOTg3Yg

    • Use the ribbon to remove the exposed battery.

  3. eUcYmdtgncEyYHCZ

    • Use the JIS #000 screwdriver to remove the six 3.0mm screws placed in the back of the ZTE Quest.

  4. TYFuGWQuddEVNDNt

    • Carefully pry open the back panel with the plastic opening tool.

  5. PZfhw4wQUPlB1FkV

    • Use a pair of tweezers to gently disconnect the ribbon cable connector from its socket.

  6. wIaZUZ3Ng2N2ewKs

    • Pull back the tape encasing the brown ribbon cable connector.

    • Remove the ribbon cable from its socket.

  7. AFRdSOEvJSBqRySZ

    • Unplug the flat-top connector by using a pair of tweezers to pry up each side before removing the connector from its socket.

  8. HPrQJGTe2xPVPNBU
    HPrQJGTe2xPVPNBU
    4nTQB1TlX3sjQT6w

    • Disconnect the coaxial connector in the bottom right corner of the motherboard.

  9. 2bWxpDMUnyZBAWVW

    • Flip the motherboard over and find the camera’s flat-top connector.

    • Gently pry up each side of the connector with a pair of tweezers before fully removing it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Eric Loureiro

Member since: 26/10/18

606 Reputation

0 comments